Subaru EyeSight 2016 Manual page 49

Adaptive Cruise Control
●
Resuming Adaptive Cruise Control in stay-stopped status
Setting using the RES/SET switch
⇒
Press "SET/-" (
Press "RES/+" (
set".)
• When Adaptive Cruise Control is resumed from stay-stopped status and
the vehicle in front accelerates, your vehicle will also accelerate and
continue to follow the vehicle in front at the previously set following
distance. However, if the lead vehicle does not start moving or pauses,
stay-stopped status will be automatically restored after approximately 3
seconds.
• While the engine is automatically stopped by the stay-stopped function and
Adaptive Cruise Control is set, the engine automatically restarts and the
Auto Start Stop indicator turns off when the vehicle in front starts moving.
Setting with the accelerator pedal
Depressing the accelerator pedal while stay-stopped is engaged cancels stay-stopped
status. At this time, Adaptive Cruise Control is resumed. The vehicle will attempt to travel
at the previously set vehicle target speed unless a lead vehicle is detected. If a lead vehi-
cle is detected, Adaptive Cruise Control will maintain the previous following distance set-
ting.
• If the accelerator pedal is only slightly depressed, the stay-stopped
function may not be cancelled, and the Adaptive Cruise Control may not be
resumed.
• When the accelerator pedal is depressed while the engine is automatically
stopped by the stay-stopped function, the engine automatically restarts
and the Auto Start Stop indicator turns off.
48
Refer to page 40 "(2) Setting Adaptive Cruise Control".)
⇒ Refer to page 53 "Returning to a vehicle speed that was previously
NOTE
NOTE