Subaru EyeSight 2016 Manual page 40

How to use Adaptive Cruise Control
Adaptive Cruise Control is available when the engine is turned on.
■ Setting Adaptive Cruise Control
(1) Setting Adaptive Cruise Control to standby status
Press the (CRUISE) switch. At this time, "
cle indicator and the "following distance setting" are displayed on the EyeSight display area
in the combination meter display.
The set vehicle speed display will read "- - km/h".
If the switch is pressed once more, the EyeSight display will turn off. It will also automatically
turn off when the engine is stopped.
To set ready status:
Adaptive Cruise Control can be set when all
of the following conditions are met and
is displayed on the EyeSight display area.
- All doors (except the rear gate/trunk) are
closed.
- The driver's seatbelt is fastened.
- The electronic parking brake is not
engaged (The brake system warning light
is turned off.).
- The select lever is in the
tion.
- EyeSight operation is not temporarily
stopped.
⇒
Refer to page 81.
- The road is not a steep slope.
- The steering wheel has not been turned significantly in either direction.
- The vehicle speed is between approximately 0 km/h and 145 km/h.
S02438
D or M posi-
Adaptive Cruise Control
" (Adaptive Cruise Control), your vehi-
S02439
S02440
39