Subaru EyeSight 2016 Manual page 72

(2) Switch to Conventional Cruise Control.
Press and hold the
seconds or longer to switch from Adaptive Cruise Control to Conventional Cruise Control.
A buzzer sounds 1 short beep.
At this time, the following distance setting indicator on the EyeSight display area of the
combination meter display turns off and
To set the ready status:
Conventional Cruise Control can be set when
all of the following conditions are met and
is displayed on the EyeSight display
area.
- All doors (except the rear gate/trunk) are
closed.
- The driver's seatbelt is fastened.
- The electronic parking brake is not
engaged (The brake system warning light
is turned off.).
- The select lever is in the
tion.
- The brake pedal is not depressed.
- EyeSight operation is not temporarily stopped.
⇒
Refer to page 81.
- The road is not on a steep slope.
- The steering wheel has not been turned significantly in either direction.
- The X-mode is not turned on.
- The vehicle speed is between approximately 30 km/h and 145 km/h.
(3) Control the accelerator pedal to reach the desired speed.
/ (following distance setting) switch for approximately 2
(Conventional Cruise Control) is displayed.
S02446
D M
or posi-
Conventional Cruise Control
S02450
S02451
71