Troubleshooting - Subaru EyeSight 2016 Manual

Troubleshooting

Adaptive Cruise control cannot be set.
Did you remember to press the
If you have not pressed the
Control) will not be shown.
Is EyeSight operation temporarily stopped?
When EyeSight is temporarily stopped,
meter display.
Set cruise control again after the reason for the temporary stop has been cor-
rected.
Is displayed?
Cruise control cannot be set when
is displayed.
is not displayed.
Are the requirements for setting cruise control met?
In any of the following cases,
• The brake pedal is depressed.
• The vehicle speed is not between approximately 0 km/h and 145 km/h
(when Adaptive Cruise Control is operating).
• The vehicle speed is not between approximately 30 km/h and 145 km/h
(when Conventional Cruise Control is operating).
• The combination meter indicates a position other than
lever or paddle shift switches are manually operated.)
• The driver's seatbelt is unfastened.
• Any door is opened (except the rear gate/trunk).
• The electronic parking brake is applied (The brake system warning light is
illuminated or flashing.)
• The vehicle is on a steep grade.
• The steering wheel is turned significantly in either direction.
• The EyeSight system is stopped temporarily.
*For details of how to release the Electronic Parking Brake, refer to the
Owner's Manual for your vehicle.
88
(CRUISE) switch?
(CRUISE) switch,
is displayed on the combination
is not displayed. Set cruise control when
will not be displayed.
*
.
(Adaptive Cruise
D
. (The select