Altera Stratix IV GX Manual page 18

1–14
Device/Power Rail Information
You select the device/power rail to work in this field. A pull-down menu with the
names of the available devices and power rails in the Stratix IV GX family is shown
when you click the corresponding cell. The tool validates the selected device/power
rail combination. A warning is shown beneath the field if an invalid combination is
chosen
Figure 1–9. Device/Power Rail Information
Component Parameters Setting
You can either enable or disable the following components of the PDN network
shown in
Figure 1–10. Parameter Settings for PDN Components
Table 1–3
Table 1–3. Parameters of PDN Components
Parameter Description
VRM to disable this component, select Ignore. To enable the VRM parasitics, select Linear, Switcher, or
Custom.
Spreading Based on the design, you can select either Low, Medium, High, or a Custom value for the effective
spreading R, L values that the decoupling capacitors see with respect to the FPGA. You can also
ignore the spreading inductance by selecting Ignore. Ignoring the spreading inductance leads to
an optimistic result and is not an accurate representation of the impedance profile that the FPGA
sees.
The Ignore option helps you understand that the spreading inductance in combination with the
BGA via inductance is the limiting factor from a PCB perspective to decouple the FPGA at high
frequencies. Be careful when choosing the Ignore option while coming up with a final capacitor
count.
BGA Via Based on the design, you can choose to Ignore the BGA via component or to Calculate the
effective via inductance based on the layout. If you are in the middle of layout, you can directly
enter the effective loop R, L via parasitics in the Library tab and choose the Custom setting under
BGA Via to include the via parasitics.
Plane Capacitance Based on the design, you can either choose to Ignore the inter-planar capacitance between the
power and ground plane, or Calculate the plane capacitance based on the layout. If you are in the
middle of layout, you can directly enter the plane capacitance in the Library tab and choose the
Custom setting under the Plane Cap to include the plane capacitance parasitics.
Power Delivery Network (PDN) Tool for Stratix IV Devices User Guide
Chapter 1: Power Delivery Network (PDN) Tool User Guide for Stratix IV Devices
(Figure 1–9).
Figure 1–10.
describes the PDN components.
Major Tabs of the PDN Tool
© March 2009 Altera Corporation