Table of Contents
Advertisement
Other Ways to Move In a Song
Changing Playback Position
Using JUMP
Besides using markers and locators to move the current time
of the song, you can also directly specify a location or
measure and beat to move to. This is convenient when
designating locations during track and phrase editing.
1. Hold [SHIFT] and press [PAGE (JUMP)].
2. "Jump" appears in the display. Use [
and the TIME/VALUE dial to enter the time location.
3. Press [F4 (Exec)]. The designated time location is
recalled, and you will return to the previous mode.
Change Playback Position Using
TIME/VALUE Dial
The current playback time in the display is shown in SMPTE
time code. The current measure, beat and marker number are
also displayed. Use the following procedure to change the
current playback position.
SMPTE Time Code (See Appendices p. 13)
1. Press [PLAY (DISPLAY)].
2. Use the [
] and [
value you wish to change.
3. Use the TIME/VALUE dial to change the value.
fig.02-06a
Hour
Minute Second Frame
Turn the TIME/VALUE dial to change the playback time
according to the position of the cursor. For example, if the
cursor is positioned under the Minutes indicator, each click
of the TIME/VALUE dial changes the timeline position by
one-minute increments. If the cursor is moved to the
subframe location, turning the dial moves the timeline
position in increments of 1/10th of a frame. To move the
timeline in 1/100th frame increments, hold [SHIFT] and turn
the TIME/VALUE dial.
] and [
] buttons to underline the time
Measure Beat
Sub Frame
Marker Number
Cursor
Chapter 3 Playback Operations
Move to the Beginning or End of
a Song Using [FF] and [REW]
1. To go to the beginning of actual recorded audio in a
song, hold [SHIFT] and press [REW (SONG TOP)].
2. To go to the ending of actual recorded audio in song,
hold [SHIFT] and press [FF (SONG END)].
fig.02-06b
1
2
3
4
5
]
6
7
8
9
10
11
12
13
14
15
16
17
18
Song Top
Song End
47
Advertisement
Table of Contents
