Table of Contents
Advertisement
Chapter 5 Using the Digital Mixer
Adjusting the Panning of Channel
Linked Channels
When Channel Link is on, it is possible to adjust the
channels' overall stereo position while preserving their pan
positions relative to each other. If you want to adjust the pan
for each channel independently, use the following procedure.
If you adjust the pan while sound is playing, you may notice
"blips" in the sound. This is not a malfunction. If you find it
annoying, adjust the pan when the sound is not playing.
1. Press the SELECT button for the input or track channel
that is linked.
2. Press [F1 (MIX)]. If "MIX" does not appear above [F1],
press [PAGE] until you see "MIX" above [F1], and then
press [F1 (MIX)].
3. Press [F6 (PRM.V)]. Each of the pan positions appears in
the display.
4. Use [
], [
], [
cursor. Then use the TIME/VALUE dial to adjust each
setting.
fig.11-22
Channel
Even-Numbered Channel Pan
Total Balance
Odd-Numbered Channel Pan
Mix Assign Switch
When this is set to "On", the source at each Input
channel is assigned directly to the MIX bus. Set this to
"on" when you simply want to mix an input without
actually recording it.
Total Balance
With the balance between both channels preserved, this
adjusts the total left-right balance (L63-R63).
Odd-Numbered Channel Pan
This adjusts the balance (L63-R63) of the odd-numbered
(left) channel.
Even Numbered Channel Pan
This adjusts the balance (L63-R63) of the even-numbered
(right) channel.
5. Press [PLAY (DISPLAY)] to return to the Playlist display.
78
], and [
] to move the
When "VS-1824" is selected on fader
mode (p. 75)
When a new song is created, CHANNEL LINK for the
DIGITAL input is ON. You can adjust parameters of
each individual channel if you turn OFF the CHANNEL
LINK. Once the CHANNEL LINK is turned OFF, you
can select the channel edit screen of the L channel on the
LCD by pressing the [DIGITAL].
To select the channel edit screen for the R channel, hold
down [SHIFT] and press [DIGITAL].
The volume of the L channel will be adjusted by moving
the [DIGITAL] channel fader.
If you want to adjust the volume of the R channel, move
the DIGITAL fader while holding the [SHIFT] down.
When "VS-1880" is selected on fader
mode (p. 75)
When a new song is created, the CHANNEL LINKs for
DIGITAL input and 7/8, 9/10, 11/12, 13/14 15/16 and
17/18 are ON. You can adjust parameters of individual
channels if you turn OFF their CHANNEL LINK. You
can select the edit screen for odd numbered channels by
pressing the [DIGITAL] button or SELECT button for the
target channel.
To select the channel edit screen for even numbered
channels, hold down the [SHIFT] and press the
[DIGITAL] button or press the SELECT button for the
target channel.
The volume of the L channel will be adjusted by moving
the [DIGITAL] channel fader.
If you want to adjust the volume of the R channel, move
the fader for DIGITAL while holding the [SHIFT] down.
Advertisement
Table of Contents
