Table of Contents
Advertisement
Chapter 4 Recording Operations
Recording to the Tracks
1. Select a track to record on. While holding down [REC],
press the STATUS button for that track. The STATUS
button will begin blinking red to indicate that it is
"record-ready."
* If you want to select TR 1-12, press [FADER/MUTE]
several times until the "TR" indicator lights.
If you want to select TR 13-18, press [FADER/MUTE]
several times until the "TR" indicator blinks.
"Switching the Fader Functions" (p. 71)
2. To select the source to be recorded to the track, press and
hold the STATUS button for the track to be recorded.
Then, press the Input SELECT button for the input you
want assigned to the track. The SELECT button will
blink.
fig.03-05
3. Press [FADER/MUTE] several times until the "IN"
indicator lights.
4. Set channel fader to the 0 dB position.
5. Adjust the input sensitivity with the INPUT knob for
each input. Provide a strong input signal by having
instrument volumes as high as possible. Raise the INPUT
level as high as possible without having the PEAK
indicator light up. The level meters should show signal
peaking between -12 dB and 0 dB.
6. Press [REC]. The button indicator blinks red.
7. Press [PLAY]. The button indicator lights green, and
recording starts.
8. When the performance, and recording, is finished, press
[STOP].
9. To listen to the recorded performance, press [ZERO] to
return to the beginning of the song.
10. Press [FADER/MUTE] several times until the "TR"
indicator lights (for tracks 1-12) or blinks (for tracks
13-18).
11. Press [PLAY] to begin playback of the song.
54
12. Use the channel faders and the Master fader to adjust
channel volumes to an appropriate volume.
13. If you are satisfied with the results of your recording,
save the song using the procedure described in "Saving
Your Song (Song Store)," p. 33.
Sources Assigned to Tracks
In a newly created song, the inputs are assigned to tracks
as shown below. This is the default mixer routing.
When "VS-1824" is selected as the fader mode (p. 75)
fig.03-05a
When "VS-1880" is selected as the fader mode (p. 75)
Advertisement
Table of Contents
