Move 2D A Aia - Roland G-800 Reference Manual

G-800 Reference Manual
WE Velo (Data 2) [LOWER/NUMBER]
As stated above, the Velo value does not necessarily refer to a velocity value. It is also used
to indicate and (on this page) set the value assigned to the control change, etc. in question —
which is why the function of the [LOWER/NUMBER] knob is called Data-2 rather than
Velo.
E Gate Time (Data-3) tUPPER/VARIATION]
Note: Press [F3] to jump back to the first insert page if you need to change something.
m Execute
Press Part Select [M.DRUMS] to confirm your settings and assign them to the event.
Move
MELO GATETIHE
¿CC 00; .Brik> ] Ms
"Brie > AS
3993.0 1.001
AIS. Dla OLCH: 37 Ei (RES 10 1 ice
Froceen) EEXi* 5
> Master page: [F4] (UsrStl)> [SHIFT] + [F2] (Micro)
Part Select [M.DRUMS] (Proceed)> [SHIFT] + [F1] (Move)
The Move function allows you move the selected event (or events) to another position. This
is the same as using the Track Shift function (see page 68) but it applies only to one or a few
events at a time.
E From [DRUMS/PART]
mM = To [ACCOMP/GROUP]
Allows you to select the last event to be moved. While rotating the [ACCOMP/GROUP]
knob, you will notice that all events you scroll through are inverted. Stop at the last event you
wish to move.
mM Proceed (Part Select (UPPER! }) f
MICRO
Move
Mix
Beebo
uti cr
EEXiL
74