Table of Contents
Advertisement
Chapter 5 Using the Digital Mixer
Selecting V-Tracks
The VS-1824 provides 16 recordable tracks per channel.
These are called "V-Tracks," short for "Virtual Tracks." By
using the V-Tracks, you can record up to 288 tracks per song.
To change V-Tracks, use the procedure below.
1. Press the SELECT button for the track whose V-Track
you wish to change. The button indicator lights. The
Track Mixer screen appears in the display.
2. Use [
], [
], [
cursor to "V. Trk" in the Track Mixer display. Or, press
[F5 (V.Trk)]. If "V.Trk" does not appear above [F5], press
[PAGE] until it appears, and then press [F5 (V.Trk)].
3. Use the TIME/VALUE dial to choose the V-Track you
want to use. Note, you cannot change the V-Track while
the song is playing. If the song is playing, press [STOP],
and then use the TIME/VALUE dial to choose the
V-Track.
fig.03-21
Track onto which performance data is recorded
Track to be recorded or played back
Tracks with no performance data recorded on them
4. Press [PLAY (DISPLAY)] to return to the Playlist display.
80
], and [
] to move the
Using the Equalizer (EQ)
Each channel of both the Input Mixer and the Track Mixer
has a user-definable EQ. You can choose either a two-band
(Low, High), or three-band (Low, Mid, High) parametric EQ
on a channel-by-channel basis. To use the EQ, first set up EQ
settings separately for each channel. Then, while listening to
the entire mix, make final adjustments to the EQ, panning,
and level for each channel.
* While adjusting the EQ when a track is playing, you may hear
short clicks, especially if you change the EQ value very
rapidly. This is not a malfunction. To avoid any such noise,
change EQ settings slowly.
1. Press the SELECT button for the track to which you want
to make EQ settings.
The Track SELECT button lights, and the Track Mixer
screen appears in the display.
2. Use [
], [
], [
cursor to the EQ section of the display. Or, press
[F2 (Low)]. If "Low" does not appear in the display
above [F2], press [PAGE] until "Low" appears above
[F2], then press [F2 (Low)].
3. Press [YES]. The EQ curve display appears.
4. Use [
], [
], [
"SW" and use the TIME/VALUE dial to select "On."
5. Use [
], [
], [
cursor to the desired EQ parameter. Use the
TIME/VALUE dial to select the desired value.
fig.03-34
Switch
Gain
Frequency
Q (definition)
Low-range
Sw (Equalizer Switch)
Turns the EQ on and off.
], and [
] to move the
], and [
] to highlight
], and [
] to move the
Selector
High-range
Middle-range
Advertisement
Table of Contents
