Table of Contents
Advertisement
Chapter 5 Using the Digital Mixer
Direct Out Connectors
The signal from each track of the recorder can be assigned
directly to each of the eight analog output jacks. This is
convenient for transferring tracks from the VS-1824 to
another multi-track recorder.
1. Press [EDIT/SOLO]. The Master Block is displayed.
2. Press [F5 (DIR)].
If "DIR" does not appear above [F5], press [PAGE] until
"DIR" appears above [F5], and then press [F5 (DIR)].
3. Use the TIME/VALUE dial to make settings for DIRECT
OUT.
DIR OUT (DIRECT OUT)
Select Tracks to be assigned as Direct Out.
Off:
Direct out is not used.
1-8:
Tracks 1-8 are output from the analog output jacks 1-8.
When DIRECT OUT is used, the MASTER, MONITOR
and AUX jacks are used for the direct track outputs. The
signals at each of the DIGITAL OUT connectors can be
set as usual.
fig.01-08.eps
Track 1:
MASTER jack (L)
Track 2:
MASTER jack (R)
Track 3:
AUX A jack (L)
Track 4:
AUX A jack (R)
AUX B jack (L)
Track 5:
AUX B jack (R)
Track 6:
Track 7:
MONITOR jack (L)
Track 8:
MONITOR jack (R)
9-16:
Tracks 9-16 are output from the analog OUTPUT jacks 1-
8. When DIRECT OUT is used, the MASTER, MONITOR
and AUX jacks are used for the direct track outputs. The
signals at each of the DIGITAL OUT connectors can be
set as usual.
74
fig.09-16
Track 9:
MASTER jack (L)
MASTER jack (R)
Track 10:
Track 11:
AUX A jack (L)
Track 12:
AUX A jack (R)
Track 13:
AUX B jack (L)
Track 14:
AUX B jack (R)
Track 15:
MONITOR jack (L)
Track 16:
MONITOR jack (R)
4. Press [PLAY (DISPLAY)] to return to the Playlist display.
Tracks 17 and 18 cannot be output directly from the VS-1824.
Remember to turn the DIRECT OUT function off when you
are finished transferring your tracks.
Advertisement
Table of Contents
