Erase - Ricoh RDC-5000 Operation Manual

Erase

The selected file is erased.
Important
• Remember that files cannot be restored once they are erased. Before
Note
starting to erase a file, make sure that you want to erase it.
q Set the mode dial to [ ] and press the
CARD/IN button to select a source file to
be erased.
An erase menu is displayed.
w Press the ▼ or ▲ button to select
[ERASE SINGLE IMAGE] and press the
ENTER button.
The erase single image menu is displayed.
Note
• To cancel the operation, set the mode
dial to another mode.
e Press the ▼ or ▲ button to select an
image file to erase.
Note
• To cancel the operation, press the
MENU button. The erase menu is
displayed.
r Press the shutter release button.
The image file thus selected is erased. If you
want to erase more files, repeat steps e and
r above.
t Press the MENU button to end the
ERASE SINGLE IMAGE operation.
The erase menu is displayed again. Then, turn
the mode dial to select another mode.
• When a lower numbered file is erased, the higher numbers are reassigned.
Note
• Erasing may take longer with some types of SmartMedia memory cards
and files.
• Protected files, which are identified by the
until they are unprotected. See "Protecting a File" (p.87).
mark, cannot be erased
4
95