Ricoh RDC-5000 Operation Manual page 38

r Press the DISPLAY button to select the
date display method.
There are three methods available to display the
date as follows:
1999/5/15
Each time you press the DISPLAY button, the
display method is switched from one position to
the next in the sequence shown above. Press
the DISPLAY button to select the desired date
display method.
t Press the ENTER button.
The date setting menu is displayed.
• To cancel the operation and return to
Note
the setup menu, press the MENU
button.
y Press the ▼ or ▲ button to change the
flashing digit.
Forwarding the digit
Press the ▲ (
button to forward the digit fast.
Reversing the digit
Press the ▼ (
button to reverse the digit fast.
u Press the ENTER button to flash the digit
you want changed.
Repeat steps y and u above to make
necessary corrections.
• Each time you press the ENTER
Note
button, the flashing digit changes, from
year to month, day, hour and minute.
i After you have set the number of
minutes, press the ENTER button again.
The clock gets started and the LCD monitor
returns to the SET UP menu. Turn the mode
dial to select another mode.
36
May 15 1999 15 May 1999
) button. Keep pressing the
) button. Keep pressing the
D A T E S E T T I N G
1 9 9 9 1
0 0 : 0 0
C A N C E L : M E N U S E L . : E N T E R
D A T E S E T T I N G
1 9 9 9 1
0 0 : 0 0
C A N C E L : M E N U S E L . : E N T E R
D A T E S E T T I N G
1 9 9 9 1
1 0 : 1 2
C A N C E L : M E N U S E L . : E N T E R
1
1
1 5