Fwe Pin Select Jumper (Jp6); Rev. 1.04 2008.07.15 (I) - Renesas M3A-HS85 User Manual

3

3.2.3 FWE Pin Select Jumper (JP6)

By setting JP6, pin FWE/ASEBRKAK
connector, or the extension connector (J13). This jumper should be set only when you want the pin FWE/ASEBRKAK
________________
ASEBRK to be controlled via the extension (J13).
Figure 3.2.4 shows FWE pin select jumper assignment. Table 3.2.3 lists jumper setting for selecting FWE pin.
Jumper Setting
JP6
1-2
FWESEL
2-3
: Initial Setting
Note: Do not change jumper settings during the operation of M3A-HS85.
Ensure to turn off the power for the M3A-HS85 before changing jumper settings.
Rev.1.04 2008.7.10
REJ10J1564-0104
_____________________ ________________
/ASEBRK of SH7285 can be switched if it is connected to SW4-3 and H-UDI
Top view of the
component side
INT
1
JP6
FWESEL
Board
edge
Figure 3.2.4 FWE Pin Select Jumper (JP6) Assignment
Table 3.2.3 FWE Select Jumper Setting (JP6)
_____________________ ________________
Pin FWE/ ASEBRKAK / ASEBRK
connector (J1 and J2).
_____________________ ________________
Pin FWE/ASEBRKAK /ASEBRK
Board
edge
E8a
3
Function
of SH7285 is connected to SW4-3 and the H-UDI
of SH7285 is connected to the extension connector (J13).
Operational Specifications
3.2.3 FWE Pin Select Jumper (JP6)
_____________________
/
3-21