Table of Contents
Advertisement
DIN RAIL MOUNTING
Use the following procedure to
mount the MP1204-XT on a DIN rail:
1.
Screw the DIN clip with screws in
the accessory kit.
2.
Hook the unit onto the DIN rail.
3.
Push the bottom of the unit
towards the DIN rail until it locks
in place.
WALL MOUNTING
Use the following procedure to
mount the MP1204-XT on a wall or
panel:
1.
Screw the wall-mount brackets
with screws in the accessory kit.
2.
Mount it to a wall or panel.
CONSOLE CONNECTION
The Console port supports local management by using a terminal emulator
or a computer with terminal emulation software, such as puTTY. The console
port is located below the power connector.
•
Baud rate: 115200bps
•
Data bits: 8
•
Stop bit:1
•
Parity: None
•
Flow control: None
Connect the RJ45 (male) connector to the MP1204-XT console port and
connect the RS-232 DB9 (female) connector cable to a COM serial port.
CONFIGURING THE IP ADDRESS
You can use the console port or a telnet connection to configure the IP
address
4
Advertisement
Table of Contents
