Digi XBee S2C Zigbee User Manual page 240

Status Transparent
code mode string Description
JV/NW with search option (DO80) has
0x08 panID Match
found a matching network.
Reject LQIRSSI JV/NW with search option (DO80)
0x09
candidate rejected because this beacon
response is weaker than an earlier beacon
response.
0x0A Beacon Saved This beacon response is a suitable
candidate for an association request.
AI AI value has changed.
0x0B
NJ setting (Permit Join Duration) has
0x0C Permit Join
changed
0x0D Scanning Active scanning has begun.
0x0E Scan Error An error occurred during active scan.
0x0F Join Request High level request for a form/join.
0x10 Reject LQI Reject because LQI is worse than an
already saved beacon
0x11 Reject RSSI Rejected because RSSI is worse than an
already saved beacon
Status data Description
panId(2) 16 bit PAN Identifier for network
radioChannel(1) channel number ranging from 11 to 26 (0x0B to 0x1A)
radioTxPower(1) low level signed byte value for transmit power, values
range from 0xC9 to 0x05 inclusive
panid(2) 16 bit PAN Identifier for network
extendedPanId(8) 64 bit PAN Identifier for network
See a description of
AIStatusCode(1)
See a description of the
value(1)
command.
A 32 bit value driven by the SC setting where bit
ChannelMask(4)
positions 11 through 26 show which channels are
enabled for the upcoming Active Scan. See a
description of
StatusCode(1)
lqi(1) link quality indicator
rssi(1) relative signal strength indicator
AI (Association Indication)
NJ (Node Join Time)
SC (Scan Channels).