Se (Source Endpoint); Destination Endpoint); Ci (Cluster Id); To (Transmit Options) - Digi XBee S2C Zigbee User Manual

AT commands

SE (Source Endpoint)

This command applies to the XBee/XBee-PRO Zigbee RF Module.
Sets or displays the application layer source endpoint value. The value is used as the source endpoint
for all data transmissions. SE is only used in Transparent mode. The default value (0xE8) is the Digi
data endpoint.
This command only affects outgoing transmissions in transparent mode (AP = 0).
0xE8 is the Digi data endpoint used for outgoing data transmissions.
0xE6 is the Digi device object endpoint used for configuration and commands.
Parameter range
0 - 0xFF
Default
0xE8
DE (Destination Endpoint)
This command applies to the XBee/XBee-PRO Zigbee RF Module.
Sets or displays the application layer destination ID value. The value is used as the destination
endpoint for all data transmissions. The default value (0xE8) is the Digi data endpoint.
Parameter range
0 - 0xFF
Default
0xE8

CI (Cluster ID)

This command applies to the XBee/XBee-PRO Zigbee RF Module.
Sets or displays the application layer ID value. Use this value as the cluster ID for all data
transmissions. CI is only used in Transparent mode.
Parameter range
0 - 0xFFFF
Default
0x11 (Transparent data cluster ID)

TO (Transmit Options)

This command applies to the XBee/XBee-PRO Zigbee RF Module.
Sets or displays the Zigbee application layer source transmit options. Use this value as the transmit
options for all data transmissions in transparent mode.
Parameter range
0 - 0xFF
Bit field:
XBee/XBee-PRO® S2C Zigbee® RF Module User Guide
Zigbee addressing commands
263