Programming E-Wand Horizontal Slat Positions - Current E-WAND Installation Manual And User's Manual

4. Optional - Make Any Necessary Adjustments
The HORIZONTAL BLIND MOUNT must
have a secure connection to the header.
Based on E-Wand positioning [Fig. 3.6,
Fig. 3.7, Fig 3.8 and Fig. 3.9], it may be
necessary to add the supplied EXTRA
ADHESIVE STRIPS to your blind's header
to build the mounting attachment
outward [Fig. 3.10].
If the HORIZONTAL BLIND MOUNT
extends beyond the top or the side of the
blind's header, use scissors to trim the
HORIZONTAL BLIND MOUNT to fit [Fig.
3.11]. If you have a valance, make sure
the top of the neck of the HORIZONTAL
BLIND MOUNT is even with or slightly
below the bottom of the valance.
5. Secure Blind Mount
Now that you have determined the final
position of the HORIZONTAL BLIND
MOUNT, verify the header is clean and
dry and that the tube of the HORIZONTAL
BLIND MOUNT is snapped into place on
the E-Wand, then remove the backing on
the adhesive strip [Fig. 3.12] and firmly
press to attach it to the blind's header.
You have now completed installing your E-Wand onto Horizontal Blinds.
Figure 3.10; (Optional) Build out Header
Figure 3.11; (Optional) Trim Blind Mount
to Fit
Figure 3.12; Remove Backing from
Adhesive Strip to Attach it to Header
14
4. programming e-wand
horizontal slat positions
E-Wand being able to move the slats. Limits are set to prevent any over-
You must program the open and close limits on the E-Wand prior to the
torquing of your blinds.
When programming the E-Wand, you will be listening for audible beeps to
assist you through the programming steps. We recommend you minimize
the noise within the room while programming the E-Wand to best hear these
beeps.
During the programming phase, if an error is made, the E-Wand will play
a short tune. This means you must restart the programming steps for that
E-Wand from the beginning.
1. Place the E-Wand into Slat Position Programming Mode
Before entering programming mode, make sure your blind slats are in the full
open position. If they are not in the full open position, move them to full open
now (you will need to unsnap the E-Wand from the neck of the HORIZONTAL
BLIND MOUNT and turn it fully to move the slats to full open).
To place the E-Wand into the Slat Position
Programming Mode, press and hold the
PROGRAMMING BUTTON until you hear
a DOUBLE BEEP(2), then release [Fig.
4.1].
NOTE: Prior to hearing a DOUBLE BEEP
(2), you will hear a SINGLE BEEP (1).
After hearing the DOUBLE BEEP (2),
release.
The E-Wand is now in Slat Position
Programming Mode.
Figure 4.1; Press and Hold Programming
Button
15