Current E-WAND Installation Manual And User's Manual page 13

3. Set the Second Position- Full Open
Twist the E-Wand TWIST HANDLE [Fig.
6.4] in the OPPOSITE direction than
in step 2 to move the slats to the FULL
OPEN position, then release the TWIST
HANDLE.
Press and hold the PROGRAMMING
BUTTON. You will hear a DOUBLE BEEP
(2) [Fig. 6.5], then release.
Note: During twisting, if you move past the full open position, do not
To get out of programming mode, power cycle the unit by partially unscrewing
twist the opposite way back to full open. Instead, restart programming.
and re-tightening the battery cap. You have successfully power cycled when
you hear a tune.
4. Set the Third Position- Full Closed Right
Twist the E-Wand TWIST HANDLE again
in the SAME direction [Fig. 6.6] as step
3 so the slats reach the FULL CLOSED
RIGHT position. Be careful not to over
tighten the slats.
Press and hold the PROGRAMMING
BUTTON. You will hear a TRIPLE BEEP
(3) [Fig. 6.7], then release.
Figure 6.4; Twist Figure 6.5;
Blinds to Full Push and Hold
Open Programming
Button
Figure 6.6; Twist Figure 6.7;
Blinds to Full Push and Hold
Closed Right Programming
Button
24
5. Set the Final Position- Full Open
Twist the E-Wand TWIST HANDLE in
the OPPOSITE direction [Fig. 6.8] than
in step 4 to move the slats back to the
FULL OPEN position. Press and hold the
PROGRAMMING BUTTON until the slats
begin to move [Fig. 6.9].
The slats will automatically move LEFT
and back to the FULL OPEN position
to confirm positions have been set
properly and that you have completed
programming the slat positions.
Note: During twisting, if you move past the full open position, do not
To get out of programming mode, power cycle the unit by partially unscrewing
twist the opposite way back to full open. Instead, restart programming.
and re-tightening the battery cap. You have successfully power cycled when
you hear a tune.
You have now completed setting the open and closed limits on the
E-Wand. You are now ready to add the E-Wand onto a Zigbee Network,
if desired [Pg. 26].
Figure 6.8; Twist Figure 6.9;
Blinds to Full Push and Hold
Open Programming
Button
25