Installing The E-Wand On Horizontal Blinds - Current E-WAND Installation Manual And User's Manual

2. Install the Horizontal Tilt Converter
Determine the size and shape of the rod
located in your header.
Locate the ADAPTER from the selection
supplied which matches your rod shape
and size and snap into the HORIZONTAL
TILT GEAR [Fig. 2.4].
Place the HORIZONTAL TILT GEAR'S
stem through the opening in the header
and slide the rod through the gear to its
original position [Fig. 2.5]. If a rod pin
or the end brackets were removed while
removing the corded tilt gear, replace
back into their original position.
You have now converted your tilt mechanism. You may now proceed to
Installing the E-Wand.
Figure 2.4; Snap in Adapter
Figure 2.5; Slide Stem through Header
10
3. Installing the e-wand on Horizontal
Make sure the blind slats are in the fully open position and the header
is free of dirt, grime, and grease. If not, use a household cleaner to clean
Before installing the E-Wand, make sure you are able to freely tilt your
the header before installation.
blinds in both directions by turning the twist wand that originally came
with your blinds. If there is significant resistance, you may need to contact
your blind manufacturer. If your blinds utilize a cord to tilt the slats, first
follow the "Converting a Corded Tilt Blind" instructions [Pg. 9].
For this installation you will need:
E-WAND
(6) AA 1.5v ALKALINE BATTERIES
HORIZONTAL BLIND MOUNT
EXTRA ADHESIVE STRIPS
WAND HOOK SLEEVE (if open hook tilt stem)
We recommend having scissors ready for instances where you may
need to trim the blind mount.
Blinds
11