Batteries; Install Or Replace Batteries; Extension Handle; Attaching An E-Wand Extension Handle - Current E-WAND Installation Manual And User's Manual

BATTERIES

20. Install or replace batteries

When the batteries are low, the E-Wand will play Beethoven's 5th while
carrying out its normal function.
1. Unscrew the Battery Cap
Using two hands, carefully and slowly
unscrew the BATTERY CAP [Fig. 20.1].
Batteries will naturally fall out of the
battery tube, so be prepared to catch
them.
2. Replace Batteries
Replace bad batteries with six (6) new
1.5v Alkaline AA batteries. Always
replace all batteries. NEVER mix old and
new batteries. Also, NEVER use damaged
or dropped batteries.
Insert batteries with the positive (+) end
first [Fig. 20.2].
3. Replace Battery Cap
Screw the BATTERY CAP back onto the end of the E-Wand securely. The
E-Wand will play a short tune to confirm the batteries have been installed
correctly.
Figure 20.1; Unscrew Battery Cap
Figure 20.2; Insert New Batteries
40

Extension Handle

21. ATTACHING An E-Wand Extension Handle

For blinds that are taller than average, it may be necessary to attach an
E-Wand EXTENSION HANDLE (sold separately) to the end of your E-Wand.
One extension handle will double the length of the TWIST HANDLE.
1. Unscrew the Battery Cap
Carefully remove the BATTERY CAP from
the E-Wand [Fig. 21.1]. Be sure not to re-
move the batteries.
2. Screw on Extension Handle
Attach the EXTENSION HANDLE onto
the end of the E-Wand. Screw tightly into
place where the battery cap was [Fig.
21.2].
3. Attach Battery Cap
Attach BATTERY CAP onto the end of the
EXTENSION HANDLE. Screw tightly into
place [Fig. 21.3].
Figure 21.1; Unscrew Battery Cap
Figure 21.2; Screw on Extension Handle
Figure 21.3; Reattach Battery Cap
41