E-Wand Non-Programming Beeps - Current E-WAND Installation Manual And User's Manual

During setup and operation you may hear some audible tones that indicate

32. E-Wand non-programming BEEPS

either confirmations or errors.
Long Monotone Beep Motor has stalled - contact customer
service.
Double Two Tone Beep Unit is powered but positions have not been
set. Set slat positions in the E-Wand.
Beethoven's 5th (4 notes) 1) Low Batteries - change batteries. If beep
persists contact customer service.
2)
interrupted - restart programming; be
sure to follow the instructions; if you
need assistance contact customer service.
3) Failure to pair to a Zigbee network. Retry
pairing; if issue persists contact customer
service.
Ode to Joy (8 notes) 1) Successful pairing to the remote; only
plays if the E-Wand limits have not yet been
set.
2) Successful pairing to a Zigbee network.
No Beeping If batteries are installed correctly and are at
full capacity and the E-Wand does not play
any tones, contact customer service.
Programming process has
50
SAFETY INFORMATION
Read all warnings and instructions prior to installing the E-Wand. Failure to follow these
instructions may result in property damage or serious personal injury.
been
Do not use the E-Wand for anything other than its intended use. Any usage of the parts of
this kit outside of its intended purposes in not covered under the warranty.
Existing blinds may have sharp edges. Use gloves to prevent cuts or abrasions whenever
removing or reinstalling blinds.
WARNING
CAUTION
CAUTION
51