Current E-WAND Installation Manual And User's Manual page 11

1. Remove Twist Wand and First Slat
Move the blind slats to the fully open position, then remove the manual twist
wand from the vertical blinds.
Remove the first vertical slat by carefully
pushing the slat upward and then
sideways to unhook it from the carrier
[Fig. 5.1].
Use the included VERTICAL BLIND
REINFORCEMENT TAPE to reinforce the
top of the first (removed) vertical slat
[Fig. 5.2] by folding it over the top evenly
so tape is on both sides of the slat. Be
sure not to cover the opening in the slat.
2. Install the Vertical Blind Mount onto the E-Wand
Install the VERTICAL BLIND MOUNT on
the E-Wand by sliding the clear plastic
bellows over the ATTACHMENT HOOK
until it fits snuggly on the E-Wand
frame [Fig. 5.3]. Install the mount so the
SENSOR SWITCHES will be facing the
inside of the room.
Figure 5.1; Remove first vertical slat
Figure 5.2; Reinforce vertical slat with
slat reinforcement tape
Figure 5.3; Install Blind Mount
20
3. Attach the E-Wand to the Vertical Blind
Pull down on the VERTICAL BLIND
MOUNT'S bellows to expose the E-Wand
ATTACHMENT HOOK. Hook the E-Wand
ATTACHMENT HOOK onto the existing
blind's tilt gear stem [Fig. 5.4].
Release the VERTICAL BLIND MOUNT
to allow the bellows to extend upwards
toward the header, covering
ATTACHMENT HOOK. Be sure the slat
attachment carrier can move through the
open slot in the blind mount [Fig. 5.5].
4. Replace First Slat
Carefully replace the reinforced slat
back onto the slat attachment carrier by
reversing the steps to remove the slat
[Fig. 5.6]. Be sure the slat is oriented
the same as the other slats within the
assembly.
You have now completed installing your E-Wand onto your vertical
Figure 5.4; Hook on E-Wand
the
Figure 5.5; Proper Positioning
Figure 5.6; Reattach Vertical Slat
blinds.
21