Remove An E-Wand From A Twist Group; Adding An E-Wand To A Twist Group - Current E-WAND Installation Manual And User's Manual

2. Assign the Master E-Wand and Close the Group
Once you have initiated the grouping
sequence on EACH E-Wand, choose an
E-Wand that will be centrally located in
the group to designate as the "master".
Press and hold THIS E-Wand's
PROGRAMMING BUTTON again until
you hear a SINGLE BEEP (1) [Fig. 13.2].
You have now completed grouping your
E-Wands and have created a Twist Group.
To confirm the group has been properly
created, each programmed E-Wand in the
group will move slightly in one direction
then back [Fig. 13.3]. Any E-Wands in
the group that have not had their slat
positions programmed will play a three-
note success tune.
The ability to create a twist group will time out after FIVE (5) minutes of
inactivity. If you have mistakenly initiated grouping on an E-Wand, simply
twist the TWIST HANDLE to remove from programming mode.
Figure 13.2; Press and Hold
Programming Button
Figure 13.3; Blind Slats will Move
36
14. REMOVING An E-Wand FROM A TWIST GROUP
In some instances, you may want to remove an E-Wand from a previously
created Twist Group. To remove an E-Wand:
Press and hold the PROGRAMMING BUTTON on the E-Wand you wish
to remove from the group until you hear a SINGLE BEEP (1), then release.
Once more, press and hold the PROGRAMMING BUTTON until you
hear another SINGLE BEEP (1), then release.
Repeat this process to remove any additional desired E-Wands from the
group.
NOTE: Removing the "master" E-Wand will eliminate the whole group.
In some instances, you may want to add an E-Wand to an existing Twist

15. ADDING An E-Wand TO A TWIST GROUP

Group. To add an E-Wand:
Press and hold the PROGRAMMING BUTTON on the E-Wand you
originally designated as the master until you hear a SINGLE BEEP (1),
then release.
On any E-Wand you wish to add to the group, press and hold the
PROGRAMMING BUTTON until you hear a SINGLE BEEP (1), then
release.
After all additional E-Wands have been initialized, return to the master
to press and hold its PROGRAMMING BUTTON again until you hear a
SINGLE BEEP (1).
All added blinds will move slightly in one direction then back (if the
positions have been set) or play a three-note success tune (if the positions
have not yet been set).
37