Setting The Preferred Closed Position; Realign Your E-Wand; Master Reset Your E-Wand; Remove The E-Wand From A Zigbee Network - Current E-WAND Installation Manual And User's Manual

When using the sensors or voice, the E-Wand may close the blinds in

16. Setting the Preferred closed position

a direction different than the direction you prefer (i.e. up or down on
horizontal blinds, or left or right on vertical blinds). To change the preferred
closed position:
Twist the E-Wand TWIST HANDLE until the slats reach your desired
closed position, then release.
Press and hold the PROGRAMMING BUTTON on the E-Wand until
you hear a QUADRUPLE BEEP (4). The E-Wand will now close to this set
position when closed by sensor triggered events.
Based on the construction of your blinds, you may notice the full open position

17. Realign YOUR E-Wand

has changed over time from it's originally programmed position. If you notice
this occurrence, you can simply realign your originally programmed E-Wand
slat positions.
Twist the E-Wand TWIST HANDLE to the position you consider to be
FULL OPEN.
Press and hold the PROGRAMMING BUTTON until you hear a
SEXTUPLE BEEP (6), then release. Your E-Wand has now been realigned
to it's originally programmed positions.
38
Master reset is performed to return an E-Wand to its factory default settings.

18. MASTER RESET YOUR E-Wand

All twist groups, paired remotes, positional settings, and learned networks
will be removed from the memory of the E-Wand.
Press and hold the PROGRAMMING BUTTON until you hear a
QUINTUPLE BEEP (5), then release. To confirm you want to perform a
master reset, the E-Wand will play a series of monotone beeps.
After you hear the beeps, press and hold the PROGRAMMING BUTTON
again until you hear a SINGLE BEEP (1). Another short tune will play, and
you will have successfully performed a master reset.
Master reset mode can be escaped by waiting until the mode times out
(30 seconds), or by twisting the E-Wand TWIST HANDLE after hearing the
monotone beeps.
In some instances you may want to remove the E-Wand from a Zigbee net-

19. Remove the E-Wand from a Zigbee network

work to either rejoin it or add it to a new network (devices can only be on
one network at a time).
Press and release the PROGRAMMING BUTTON (7) times to remove
the E-Wand from a Zigbee network.
The E-Wand should play a tune to confirm you have successfully removed
the E-Wand from a Zigbee network.
NOTE: You will need to add the device back to a network to control it
using the app or voice.
39