Programming E-Wand Vertical Slat Positions - Current E-WAND Installation Manual And User's Manual

6. PROGRAMMING E-WAND VERTICAL
SLAT POSITIONS
E-Wand being able to move the slats. Limits are set to prevent any over-
You must program the open and close limits on the E-Wand prior to the
torquing of your blinds.
When programming the E-Wand, you will be listening for audible beeps to
assist you through the programming steps. We recommend you minimize
the noise within the room while programming the E-Wand to best hear these
beeps.
During the programming phase, if an error is made, the E-Wand will play
a short tune. This means you must restart the programming steps for that
E-Wand from the beginning.
1. Place the E-Wand into Slat Position Programming Mode
Before entering programming mode, make sure your blind slats are in the full
open position. If they are not in the full open position, move them to full open
now (you will need to remove the first slat and pull the bellows downward
while turning the E-Wand to move the slats to full open).
To place the E-Wand into the Slat Position
Programming Mode, press and hold the
PROGRAMMING BUTTON until you hear
a DOUBLE BEEP(2), then release [Fig.
6.1].
Note: Prior to hearing a DOUBLE BEEP
(2), you will hear a SINGLE BEEP (1).
After hearing the DOUBLE BEEP (2),
release.
The E-Wand is now in Slat Position
Programming Mode.
Figure 6.1; Press and Hold Programming
Button
22
2. Set the First Position- Full Closed Left
Twist the E-Wand TWIST HANDLE [Fig.
6.2] to move the slats of the blind to
the FULL CLOSED LEFT position, then
release the TWIST HANDLE.
Be careful not to over tighten slats, as
over tightening can cause damage to
the blind.
Press and hold the PROGRAMMING
BUTTON until you hear a SINGLE BEEP
(1) [Fig. 6.3], then release.
Figure 6.2; Twist Figure 6.3;
Blinds to Full Push and Hold
Closed Left Programming
Button
23