Pairing A Remote Control To The E-Wand - Current E-WAND Installation Manual And User's Manual

23. Pairing a remote control to the E-Wand

For further assistance pairing a remote to the E-Wand, please view our
online Instructional Videos at www.myewand.com/support.
Pairing an E-Wand to the remote can be performed before or after
installation and programming.
1. Enter Pairing Mode
Press the PROGRAMMING BUTTON on
each E-Wand you wish to pair to the re-
mote until you hear a SINGLE BEEP (1)
[Fig. 23.1], then release.
2. Select the Desired Channel
Press and release the CHANNEL button
until the LEDs reflect the desired channel
you wish to set [Fig. 23.2].
Figure 23.1; Press and Hold
Programming Button
Figure 23.2; Depress the Channel Button
44
3. Pair the Remote
Use a tack, pen, or paperclip to press
and release the PAIRING button on the
back of the remote [Fig. 23.3] When
this button has been pressed, the LED's
on the front of the remote will scroll to
confirm.
To PAIR, press the top left button on
the tilt toggle [Fig. 23.4]. The blind(s)
will move slightly in one direction then
back, indicating that it has received the
command and completed the process.
If you ever need to unpair, you can repeat
the same steps and press the lower left
button on the tilt toggle to unpair [Fig.
23.5].
Figure 23.3; Press in Tack or Pen
Figure 23.4; Press to Pair
Figure 23.5; Press to Unpair
45