Setting Up An Optional Remote Control; Remote Control Diagram And Button Descriptions - Current E-WAND Installation Manual And User's Manual

Setting up an optional
remote control
22. Remote Control Diagram and button
descriptions
Tilt Up/ Left
Tilt Down/ Right
Channel Selector
Full Up/ Left
Full Open
Full Down/ Right
Favorite
Channel LEDs
42
Briefly press and release to move the slats in the open or closed direction
TILT TOGGLE
and stop at the next position setting. There are seven (7) position settings
from the full up to the full down position. The user may also press and hold
the toggle button until the slats get to the desired position, then release the
toggle.
Used to customize control of multiple blinds on a single remote. The currently
CHANNEL SELECTOR
selected channel is indicated by the Channel LEDs. Pressing the CHANNEL
Button once will display the current channel. Pressing it again will switch to
the next channel. When all LEDs are lit, the remote is selected to broadcast
on all channels.
Moves the slats to the full up position for horizontal blinds or full right
FULL UP/ LEFT
position for vertical blinds.
Moves all slats to the full open position.
FULL OPEN
Moves all slats to the full down position for horizontal blinds, or full left
FULL DOWN/ RIGHT
position for vertical blinds.
The user can program this button to any position they choose to be their
"favorite" position; however, if left unchanged it will move the slats to
approximately half way between the full open and the full down/ left position.
FAVORITE
43