Installing The Sfp Transceiver - Planet WSD-800 User Manual

2.2.3 Installing the SFP transceiver

The sections describe how to insert an SFP transceiver into an SFP slot.
The SFP transceivers are hot-pluggable and hot-swappable. You can plug-in and out the transceiver to/from any
SFP port without having to power down the Switch. As the Figure 2-9 appears.
Approved PLANET SFP Transceivers
PLANET WGSD-910 / WGSD-1022C support both single mode and multi mode SFP transceiver. The following list
of approved PLANET SFP transceivers is correct at the time of publication:
■MGB-SX SFP (1000Base-SX SFP transceiver )
■MGB-LX SFP (1000Base-LX SFP transceiver )
It recommends using PLANET SFPs on the Switch. If you insert a SFP transceiver that is not
Notice:
supported, the Switch will not recognize it.
Before connect the other switches, workstation or Media Converter.
1. Make sure both side of the SFP transfer are with the same media type, for example: 1000Base-SX to
1000Base-SX, 1000Bas-LX to 1000Base-LX.
2. Check the fiber-optic cable type match the SFP transfer model.
To connect to 1000Base-SX SFP transceiver, use the multi-mode fiber cable- with one side must be
male duplex LC connector type.
To connect to 1000Base-LX SFP, transceiver use the single-mode fiber cable-with one side must be
male duplex LC connector type.
User's Manual of WSD-800 / WGSD-910/WGSD-1022C
Figure 2-9 Plug-in the SFP transceiver
-15-