Related Manuals for Planet WNRT-320GS
Summary of Contents for Planet WNRT-320GS
- Page 1 3G / 802.11n Wireless Portable Router with 3G HSUPA WNRT-320GS Quick Installation Guide...
-
Page 2: Table Of Contents
Table of Contents 1. Package Contents ..........3 2. Physical Introduction ..........4 3. Hardware Installation ..........5 4. Web UI Configuration .......... 10 5. Further Information ..........12... -
Page 3: Package Contents
1. Package Contents Thank you for choosing PLANET WNRT-320GS, the most convenient wireless portable 3G router. Before installing the router, please verify the contents inside the package box. WNRT-320GS Quick Guide CD-ROM Power Adapter USB Cable Ethernet Cable Li-ion Battery If there is any item missed or damaged, please contact the seller immediately. -
Page 4: Physical Introduction
2. Physical Introduction Top Panel Description Power/Battery Wireless Connection WAN/LAN 3G Connection Front Panel Description RJ-45 Port Power Connector The Switch of Router and AP Modes Power Switch Side Panel Description WPS Button Reset Button... -
Page 5: Hardware Installation
3. Hardware Installation Please follow the instructions below to activate the WNRT-320GS. Step 1: Remove the cover in the bottom of the machine. You can choose to insert the SIM card into the slot for 3G connection, or connect WNRT-320GS... - Page 6 ON/OFF AP/RT Step 2: Make sure the operation mode by the hardware switch is at Router Mode (default setting). ON/OFF AP/RT Step 3: Connect power adapter with WNRT-320GS if necessary. And then turn on it. ON/OFF AP/RT ON/OFF AP/RT...
- Page 7 Step 4: Use your PC equipped wireless adapter to site survey the wireless signal of WNRT-320GS, and connect your PC with it wirelessly. Default SSID: default Default Wireless Encryption: WPA-PSK / WPA2-PSK Default Password: 1234567890 1. When the WNRT-320GS is at Router Mode, the only RJ-45 port will act as a WAN port.
- Page 8 2. If you cannot obtain an IP address automatically from the WNRT-320GS at Router Mode after clicking the Connect button screen, please follow the procedures below to configure the Windows Network Connection. Step 1. Click “Start” button located at lower-left corner of the screen.
- Page 9 Step 7. Select “Obtain an IP address a utomatically” and “Obtain DNS server address automatically”, then click “OK”. Note...
-
Page 10: Web Ui Configuration
4. W eb UI Configuration Default IP Address: 192.168.1.1 Default Username: admin Default Password: admin Step 1: Open the Web browser and enter the default IP address http://192.168.1.1 The default username and password are both “admin”. Then click OK button to continue. - Page 11 You have already finished the configuration of the WNRT-320GS. Now you can use your iPhone, iPad, laptop, and any other Wi-Fi devices to connect with it wirelessly and start surfing the Internet.
-
Page 12: Further Information
5. Further Information The above introductions are simple installations and configurations for WNRT-320GS. For further configurations of 3G, WAN, LAN, Wireless Security, Firewall, Routing, Port Forwarding, DMZ, and DDNS, etc., please refer to the user’s manual in the CD attached in the package.