Planet WSD-800 User Manual page 43

2. Bridge Information
The informations of the STP Root show in the Bridge Information table.
3. STP Port Configuration
On the STP port configuration, the settings are implemented on a. per user-defined Group of ports.
The following fields can be set for STP port configuration:
Edge Port: Defines if this port connected directly to a single workstation, or this port that is directly connected to a
LAN segment where a loop cannot be created. For example, this port is connected to a PC, Print-Server, IP
camera or any other network end-node device. Since end nodes cannot cause forwarding loops, they can pass
directly through to the spanning tree forwarding state.
There are two selections for this function:
True - This port connected directly to a end-node device or LAN segment where a loop cannot be
。
created
False – This port connected to one or more LAN segments – maybe a ethernet switch or HUB, that a
。
loop might be occured
P2P Status: Enables or disables the device to establish a point-to-point link, or specifies for the device to
automatically establish a point-to-point link. A P2P port is also capable of rapid transition. P2P ports may be used
to connect to other bridges. Under RSTP, all ports operating in full-duplex mode are considered to be P2P ports,
User's Manual of WSD-800 / WGSD-910/WGSD-1022C
-43-