Planet WSD-800 User Manual page 100

8-port 10/100mbps + 1-2 gigabit tp/sfp combo managed ethernet switch

Hide thumbs Also See for WSD-800:

Table of Contents

After the down the Port 1 VLAN configuration, press "close" to back to the 802.1Q VLAN main screen. And

check if the setting be applied to Port 1 at the "Egress Policy" column. The screen in Figure 7-5 appears.

Assign the VLAN 2 and VLAN 3 group member. At this case, Port 2 had been assigned to as VLAN 2 group

member and Port 3 be assigned to as VLAN 3 group member.

Repeat step 2 to step 7, expect that :

• Configure the Port 2 with PVID=2, Port 3 with PVID=3.

• The link type of both Port-2 and Port 3 are "Always Untag".

• And both Port 2 and Port 3 are VLAN 1 members.

10. After properly configure the 802.1Q VLAN per port setting, it should be as the screen in Figure 7-6 appears.

Figure 7-4 Assign Port-1 to be VLAN 2 and VLAN 3 member.

Figure 7-5 Port 1 VLA N status

User's Manual of WSD-800 / WGSD-910/WGSD-1022C

-100-

Table of Contents

Wgsd-910 Wgsd-1022c