Table of Contents
Advertisement
Figure 104. Installing the serial COM port
Next steps
1.
Install the air
shroud.
2. Follow the procedure listed in
VGA module
Removing the VGA module
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. If installed,
Remove the front
4.
Remove the backplane
5. If installed,
Remove the air
NOTE:
Ensure that you note the routing of the cables as you remove them from the system board. Route the cable
properly when you replace it to prevent the cable from being pinched or crimped
Steps
1. Disconnect the VGA cable from the connector on the system board and open the cable latch.
2. Disconnect the right control panel cable from the system board and move it away to see the VGA module screw on the
system.
140
Installing and removing system components
After working inside your
Safety
instructions.
Before working inside your
bezel.
cover.
shroud.
system.
system.
Advertisement
Table of Contents
