Table of Contents
Advertisement
8. Push the lever on the handle bar completely
forward, read on the tester the tension value:
this should be equal to the battery tension,
otherwise
act
upon
(maximum voltage), until the tester indicates
the correct value.
9. Recheck
the
minimum
trimmer
Vmin. Bring the lever back to try the
drive: check that the measured tension is less
than the maximum value.
10. Check the motor braking releasing the drive:
the machine must stop within 1 metre.
Inspection Water Supply
1. Check the cleanness of the transparent
eventual water leakages.
2. Fill completely with water the solution tank
3. Check the tightness of the hoses, the
complete opening and closing of the water cock
* THE SOLENOID VALVE IS AVAILABLE ONLY ON MACHINES WITH
KIT
4. Check that the detergent solution, when the cock is open, arrives
with continuity onto the floor
5. With the closed cock, check that there are not any solution
leakages
Inspection Suction
1. Check the cleanliness and functionality of the
2. Check the air seal of the
3. Check the connections and their tightness of the suction hoses
and the squeegee hose
4. Check the tightness of the hose and of the exhaust plug
ADJUSTMENTS
AND
INSPECTIONS
the
trimmer
Vmax
values
with
the
solution
.
solenoid
.
filter float
cover
on the recovery tank
.
MAXIMA
filter. Check also
valve* and the
.
.
.
.
Doc.
10004809
Emesso dec -06
Rev.
00
Pag.
2 di 7
Advertisement
Table of Contents
Need help?
Do you have a question about the MAXIMA and is the answer not in the manual?