Thermo Scientific Smart-Vue Administrator's Manual page 94

TCP/IP dry contact device
17.6.2 Configuring TCP/IP
Dry Contact device settings
88 Administrator Guide v 2.2
• Connect the device's Ethernet cable to your network.
• To ensure that the AC adapter does not get unplugged accidently, use a
power socket that is also elevated from the floor and/or shield the cord
in a protective conduit that is fixed to the wall or contained within the
wall.
• The TCP/IP Dry Contact device is a critical device in your wireless
monitoring system. Therefore, we recommend that you keep it plugged
it into an Uninterruptible Power Supply or safety plug.
The next step is to use your Web browser to connect directly to the Dry
Contact in order to configure its basic parameters.
Smart-Vue TCP/IP Dry Contact devices are delivered with a default IP
address to ensure that you can access them over your network. The default
IP address is: 192.168.0.110.
To adapt the TCP/IP Dry Contact device for use in your network, do the
following:
1. Open your Internet browser (e.g., Internet Explorer).
2. Type 192.168.0.110 in the address bar, and then press Enter on your
keyboard.
3. Click on OK if you are prompted to enter a login name and password.
Figure 49. Network Configuration Interface (Main Screen).
4. Click on Network in the left-hand panel, and fill in the IP Address,
Subnet Mask, Default Gateway and DNS Server fields to match your
network. Contact your system administrator if necessary.
Thermo Scientific Smart-Vue
®
Wireless Monitoring Solution