Thermo Scientific Smart-Vue Administrator's Manual page 59

12.5.3 Outgoing Mode (Direct
Connect) Specific Parameters
Thermo Scientific Smart-Vue
3. Leave all other settings at their default values on this screen (provided in
the Appendix for your information), except for those in Endpoint
Configuration, which should be set as follows:
Field
Local port
Remote port
Remote host
(IP or name)
Auto
increment
for
connect
4. Click on OK (Done! must appear next to the button).
5. Click on Apply Settings in the left-hand panel to save your
configuration changes to the network receiver. This transfers the
configuration to the receiver and restarts it automatically.
6. You may close your browser after the configuration is saved.
1. Under Passive Connection, use the Accept Incoming pull-down menu
to select Yes.
2. Under Active Connection, make sure the Active Connect pull-down
menu is set to None.
®
Wireless Monitoring Solution
Description
TCP port
(on Smart-Vue
Server computer)
used to establish
TCP/IP
communications.
The computer
running
Smart-Vue
Server.
active
Setting
0
Typically 10001 (to be confirmed by your IT
department or system administrator; this can
be the same number as Local port). This port
must be open for incoming communications
both on the network
Smart-Vue Server computer, and on the
server computer itself. (This number is
entered later in Smart-Vue Client, see
Section 12.6.1 Adding the new network
receiver).
IP address
Checked
Administrator Guide v 2.2
TCP/IP Receiver
containing the
53