Configuring The Emulated Serial Port - Thermo Scientific Smart-Vue Administrator's Manual

Power-over- Ethernet (POE) TCP/IP Receiver
13.8 Configuring the
Emulated Serial Port
70 Administrator Guide v 2.2
4. Enter the IP Address, Default Gateway, Hostname, Domain, DHCP
Client ID, Primary DNS, Secondary DNS fields to match your
network. This information is dependent on having an available static
address. Contact your system administrator if necessary.
CAUTION: If you intend to use a host name to connect to your server,
you must fill in both the Hostname and DNS Server fields here.
By default, the Network Mask is set to 255.255.255.0.
5. Important: Click on Submit to save your changes.
1. In the left-hand menu bar, click on Line
Figure 40. Emulated serial port configuration
2. Set these values as follows:
State = Enabled
Protocol = Tunnel
Baud Rate = 9600
Data Bits = 8
Flow Control and Parity = None
Stop Bits = 1
Line 1

Thermo Scientific Smart-Vue
Configuration:

®
Wireless Monitoring Solution