Compressor control and surveillance
1) Only shown while capacity is limited.
2) If limiter is active (suction pressure > alarm limit), it will remain active until the pressure falls below the
alarm limit less 2°C/R.
3) Limiter is not active or passive like standard limiters. It actively limits capacity so that it is less than or
equal to the selected High limit.
3.2.5
Display indications (reciprocating compressors)
The following table shows the display texts for limiters.
Limiter
Low suction pressure
High discharge pressure
High motor current
Low brine temperature
High water temperature
High differential pressure
High suction pressure
Suction ramp
High discharge
temperature
High liquid level
High suction pressure
gradient
Table 28: Display indications - reciprocating compressors
1) Only shown while capacity is limited.
2) If limiter is active (suction pressure > alarm limit), it will remain active until the pressure falls below the
alarm limit less 2°C/R.
3) Limiter is not active or passive like standard limiters. It actively limits capacity so that it is less than or
equal to the selected High limit.
4) Limiter is active as long as the liquid level is high. When the liquid level gets low, limiter is passive until
the delay timer runs out.
Engineering manual - UniSAB III 1.10.8
001930 en 2021.06
Overview picture indication
Compressor
Compressor
stopped
running
Standard Limiters:
Pause
Suction lim.
Pause
Discharge lim.
Irrelevant
Running
overload
Pause
Suction lim.
Pause
Discharge lim.
Irrelevant
Discharge lim.
Special limiters:
Ready
Suction lim. 1)
Irrelevant
Suction lim.
Irrelevant
Irrelevant
Irrelevant
Irrelevant
Irrelevant
Irrelevant
101/346
Alarm picture,
Passive
Active indication
indication
None
Suction pressure
None
Discharge pressure
None
Limiting brine
Brine temperature
temperature
low lim. and limiting
brine temperature
Limiting hot water
Brine temperature
limiting hot water
None
High differential
None 2) 3)
Suction pressure
None
None
Limiting discharge
High liquid level 4)
High liquid level 4)
None
High suction pres-
Alarm picture,
low lim.
high lim.
None
high lim. and
pressure
high lim. 3)
None
temperature
sure gradient
Need help?
Do you have a question about the SABROE UniSAB III and is the answer not in the manual?
Questions and answers
What is the user code for the Unisab 3.