The Top Line Of The Display; Altering Parameters - Eventide Eclipse User Manual

You know you're a level down because a little triangle appears in the lower right corner of the
screen. To come "back up," press the area key for the area you're in
. Try this on
)
LEVELS
(parentheses)
are for individual parameters. Here we see
(WET/DRY)
This special soft key sends you "up a level." Here we see
^_BACK
PARAMETER <EDIT MOD>
been pressed a few times. Pressing
to the normal
Before we move on to the top line of the display, we should point out a
little graphic you may notice on the bottom right corner of the screen. It's a
number next to a right pointing arrow. This graphic indicates that the area
you're in has more than one "page." The number is the page you're on.
Pressing after being in some other area will result in the screen to
LEVELS
the right. As shown, we're on page 1 and we know there are other pages
because there's an arrow.
To flip to the other pages, press the area key associated with those pages.
Here we've pressed the
relative to the page number. If the arrow is to the left of the page number,
it indicates that pressing the
page.

The Top Line of the Display

The top line of the display usually shows what area you're in (e.g.,
, , etc.) and the parameter value for the highlighted soft
SETUP PROGRAM
key.
The area breaks from this convention a bit, with the first
PARAMETER
page showing which algorithms are loaded into each effects block and
whether each effects block is muted or not. You'll find a few other such
anomalies, but they shouldn't be too hard to figure out.
Once you highlight a (NORMAL)
the display will show a parameter (or parameters) that you can adjust. To
adjust a parameter you can...
• Turn the knob!
• Key in a value with the keypad, pressing
pressing either before the keyed number or after the keyed number. If you key in a number that is
+/-
"out of range," the highest or lowest value available will be shown. If you don't press
you typed won't "stick"!
you key in a delay time of 333.333
• Press the
/
INC DEC
Release 2.500
Eclipse User Manual
LEVELS METER
.
after the
area screen.
PARAMETER
key again. Notice the position of the arrow
LEVELS
key again will take us back to the first
LEVELS

Altering Parameters

or {GANGED}
ENT
NOTE: You can often obtain greater precision than the display will show by keying in a value. For example, if
, the display will read 333
keys (the little up and down arrow in the keypad).
Page 13 of 64
.
LEVELS
key has
PARAMETER
sends us "up"
^_BACK
LEVELS
soft key, the top line of
when you're finished. Negative values can be entered by
. But the actual value will be 333.333
(in this example, we'd press
,
ENT
!
Eclipse User Manual
, the number