Dedicated External Controllers - Eventide Eclipse User Manual

for con are 0 to 31. The MIDI control number con will pass the "coarse" value for the
modulation and the MIDI control number
the modulation.
MIDI channel pressure message.
chan pressur
MIDI pitch bend message.
pitch wheel
MIDI keyboard note number. Middle C on an 88-note keyboard gives a value of "60."
note on
Triggers when a MIDI note on event is received.
Note switch
Triggers when a MIDI program change message is received.
MIDI program
Modulates as a function of the BPM (beats per minute) of a MIDI clock signal. The value of
MIDI clock
this external controller is
so 120BPM yields a value of 0.25, 96BPM yields a value of 0.2, and so on. This MIDI mes-
sage is channel-independent.
MIDI start Triggers when a MIDI start command is received. This MIDI command is channel-
independent.
MIDI stop Triggers when a MIDI stop command is received. This MIDI command is channel-
independent.
No external controller will be connected.
off
For all of the above MIDI messages (except for those involving "MIDI
clock"), if page 2
SETUP
message will be accepted on any channel.
On the other hand, if
SETUP
channel (e.g., ), then you must select the channel that the external control-
6
ler will be accepted on.
Jumping back to
SETUP
Your selection is made relative to the channel selected in the MIDI setup. In
the example shown to the right, our base channel is
spond to MIDI messages on channel 8 (6 + 2 = 8).
As opposed to "manually" selecting a MIDI controller along with its
proper channel and control number, a feature exists that "captures" the
first MIDI message sent to the Eclipse. Press
page 2
EXT#1 <CAPTURE>
you would like to use.
As well as the eight general-purpose controllers described above, there are
also a number of single-purpose External Controllers.
(BYPASS) Allows you to bypass the Eclipse from a foot switch or MIDI source. Using this controller is
the same as hitting the
(PGM +) Allows you to select a foot pedal or a MIDI source to load the next highest program. This
can be useful in a live performance. Of course, this can be set to
Release 2.500
Eclipse User Manual
input_BPM / 480 = value
is set to
MIDI (CHANNEL)
page 2 MIDI (CHANNEL)
page 3
EXTERNAL EXT#1
, and then send the Eclipse the MIDI message

Dedicated External Controllers

switch on the front panel.
BYPASS
Page 45 of 64
(CNTRL)
, then the MIDI
Omni
is set to a specific
, select
(CHANNEL)
so will re-
6 EXT#1
page 3 EXTERNAL
SETUP
+ 32 will pass the "fine" value for
.
see pages 8 and 24 for more on
as well.
Off
Eclipse User Manual
Bypass