Polycom KIRK Wireless Server 500 User Manual page 4

1.0 KIRK Wireless Server 500
The present User Guide has been prepared and published by Polycom. This User Guide
describes the installation of the KIRK Wireless Server 500.
Polycom reserves its right to make revisions of the content without any prior notice whether the
changes refer to typographical errors, inaccuracies in actual information or improvements of
programs and/or equipment. Potential changes will be included in later editions of the present
User Guide. All rights reserved.
Before installing the KIRK Wireless Server 500, please read carefully the present User Guide.
Attention
You will experience some inconsistencies between the product names used in the User Guide
and the Administration Program and ServiceTool. Below is a list of the product names in
question and their equivalent:
User's Guide
KIRK Wireless Server 500
Administration Program
1.1 The Box Contains
•
A KIRK Wireless Server 500.
•
A power supply
•
Quick guide.
1.2 KIRK Wireless Server Features
•
Eight analogue (a/b) lines to be connected to the PBX.
•
An RJ45 serial connection for messaging and a programming interface elsewhere referred to
as RS-232.
•
The capacity of up to 8 handsets and 6 simultaneous calls.
•
Caller ID (CLIP) Displays Calling Number Identification of incoming call. (Only for variant
supporting CLIP – only FSK Bell 202).
White list for PBX's that supports the CLIP functionality can be found at
www.kirktelecom.com/Installer/suk219.asp
Important note on Caller ID (CLIP)
CLIP displays 12 characters (in case the number is longer than 12 characters, only the last 12
characters are shown. However the full number is stored in the CLIP stack).
Application Software
Dect system 500, CCFP, Control Unit
CCFP Administration Program
KIRK Wireless Server 500 with CLIP – User Guide - 14096500-HD, Ed.8 3