Section 2: Installation - Emerson Keystone OM13 - EPI2 Installation, Operation And Maintenance Manual

Installation, Operation and Maintenance Manual
VCIOM-01495-EN Rev. 1

Section 2: Installation

To assemble the OM13 into the EPI2 actuator, proceed as follows:
•
•
•
•
•
Figure 1
Figure 2
Follow one of the following assembling procedures depending on actuator model.
Installation
Ensure that all the parts received with the OM13 are available as described in
Section 4.
Using Section 4, select only mechanical parts (screws and spacers) depending on
actuator models.
Gather the right tools for the assembly and for setting the actuator controls.
With an Allen wrench of 5 mm, unscrew the cover screws as shown in Figure 1.
Remove the actuator cover as shown in Figure 2.
Section 2: Installation
May 2022
3