Emerson Keystone OM13 - EPI2 Installation, Operation And Maintenance Manual page 14

Section 2: Installation
May 2022
•
•
Figure 17
Figure 18
•
•
10
Remove the 3-wire power connector cable from the power card as shown in Figure 17.
Remove the 2-pins connector cable from J1A on the logic card as shown in Figure 18.
Connect the 3-wire power connector cable from the terminal board to the OM13
as shown in Figure 19.
Place the OM13 card onto the heatsink spacers (if necessary use 3.2 mm height
plastic spacers) and tighten the 4 screws as shown in Figure 20.
Installation, Operation and Maintenance Manual
VCIOM-01495-EN Rev. 1
Installation