Raven Hawkeye 2 Installation Manual page 28

Hide thumbs Also See for Hawkeye 2:

Table of Contents

CHAPTER 4

BUMPER INSTALLATION FOR MACHINES WITH PROSTOP-E VALVES AND WILGER NOZZLE BODIES

It is necessary to add spacers to the boom bump stops to help prevent nozzle bodies from colliding with each

other upon folding, causing damage to the nozzle bodies. To install bump stop spacers:

1. Locate the boom stops shown in Figure 6, "Boom Stop," and remove the existing hardware. Keep the existing

washers and nuts.

FIGURE 6. Boom Stop

2. Place two boom stop spacers (P/N 107-0172-609) behind the boom stop.

FIGURE 7. Installed Boom Spacers

3. Use the longer bolt provided in the kit (P/N 311-0070-014) and the original nuts and washers to secure the

boom stop and spacers.

Hawkeye® 2 Installation Manual for AGCO Fendt RoGator 900 Series

Table of Contents