Skyjack SJKB-40-D Operating Maintenance Instructions & Part List page 9

General Work Conditions
Read and pay attention to all labels on the unit.
DO NOT
exert excessive side forces on platform while
elevated.
DO NOT
overload, the lift relief valve does not protect
against overloading when the platform is elevated.
DO NOT
alter or disable limit switches or other safety
devices.
DO NOT
raise your platform in windy or gusty
conditions.
DO NOT
exceed the rated capacity of your unit. Make
sure the load is evenly distributed on the platform.
Jobsite Hazards
DO NOT
operate the unit on surfaces not capable of
supporting the weight of the work platform, including the
rated load, e.g. covers, drains and trenches.
BE AWARE
of overhead obstacles, especially
electrical lines. Also be aware of poorly lit areas that
might hide overhead obstacles.
SECTION 1, Page 2
DO NOT
firm level surfaces. Avoid pot holes, loading docks,
debris, drop offs and surfaces that my affect the stability
of your work platform.
DO NOT
while in travel mode. Boom elevated driving must be
done only on firm surfaces. (Ref. Table 1-1)
ENSURE
travel.
Work Platform Conditions
An operator should not use any work platform that:
Has ladders, scaffolding or other devices mounted on it
to increase its size or work height.
Does not have a clean, uncluttered work area.
Does not appear to be working properly.
Has been damaged or appears to have worn or missing
parts.
Has alterations or modifications not approved by the
manufacturer.
Has safety devices which have been altered or disabled.
Figure 1-1. Front Panel Labels
DEC. 1999
JUN. 1999
elevate the work platform if the unit is not on
climb or descend a grade steeper than 30%
that there is no person(s) in the path of
SJKB-40-D, SJKB-40-D/F