Inserting The Transmitter Into The System - GE VeriDri User Manual

Operating Instructions

3 Inserting the Transmitter into the System

CAUTION!
process line, you must consult GE for proper installation
instructions and precautions before beginning the following
procedure.
Complete the steps below to install the VeriDri:
Make sure the sintered or sheet stainless-steel shield is in place. The
1.
shield protects the aluminum oxide sensor from damaging elements
in the process.
The probe is mounted into the process via the 3/4-16 straight male
2.
thread located on the probe. Thread the probe end of the transmitter
into the process/sample system fitting, making sure not to cross
thread it.
4
If you are mounting the VeriDri directly into the
3/4-16 UNF-2A
Shield
VeriDri™ User's Manual