Insertion Into The Sample System/Process - GE HygroTrace User Manual

Insertion into the Sample System/Process

If the HygroTrace is being installed directly into
the process line, consult the factory for proper
installation instructions and precautions before
beginning the following procedure.
No maintenance of the sensor can be performed in the
field. Accessing the sensor chamber will break the VCR
seal and should be done only at the factory.
To install the transmitter, refer to Figure 2 below and use a
wrench to thread the female 1/4" fittings of the sample system or
process line onto the 1/4" male VCR fittings of the tee sample
cell configuration.
Tee Sample Cell
Figure 2: HygroTrace Installation
HygroTrace Moisture Transmitter
!CAUTION!
!CAUTION!
1/4" VCR (Male)
September 2007
2 places
3