Displaying The Operational Statistics Of The Firewall; Displaying Transceiver Module Information - H3C SecPath F100-X-G3 Installation Manual

Field

Displaying the operational statistics of the firewall

When you perform routine maintenance or the system fails, you might need to view the operational
information of each functional module for locating failures. Typically you need to run
commands one by one. To collect more information one time, you can execute the
diagnostic-information
multiple functional modules of the firewall.
•
Save the operational statistics of each functional module of the firewall:
<Sysname> display diagnostic-information
Save or display diagnostic information (Y=save, N=display)? [Y/N]:y
Please input the file name(*.gz)[flash:/diag.gz]:
Diagnostic information is outputting to flash:/diag.gz.
Please wait...
Save successfully.
To view the diag.gz file:
a. Execute the
b. Execute the
c. Press Pg Up and Pg Down.
•
Display the operational statistics for each functional module of the firewall:
<Sysname> display diagnostic-information
<Sysname>display diagnostic-information
Save or display diagnostic information (Y=save, N=display)? [Y/N]:n
===============================================
===============display cpu===============
Slot 1 CPU 0 CPU usage:
...

Displaying transceiver module information

Identifying transceiver modules
To identify transceiver modules, you can use the following command to view the key parameters of
the transceiver modules, including transceiver module type, connector type, central wavelength of
the laser sent, transmission distance, and vendor name or name of the vendor who customizes the
transceiver modules.
To display transceiver module information:
Task
Display key parameters of the
transceiver module in a specific
interface.
Description
powers off when the temperature exceeds this threshold.
command in any view to display or save the operational statistics of
gunzip diag.gz
more diag
13% in last 5 seconds
13% in last 1 minute
13% in last 5 minutes
command in user view to decompress the file.
command.
Command
display transceiver
interface
[ interface-type
5-35
display
display
Remarks
Available for all transceiver
modules.