Filling The Ice Bath - Cornelius QUEST ELITE 2 FLAVOR Installation Manual

Table of Contents

The ice bath holds approximately 3.5 gallons (13.4 liters) of water. The fill tube is located behind the front splash plate and

capped with a 0.5" plug.

Remove the 0.5" plug and attach the tube to any one of the dispense nozzles.

Open the door and verify that the flush/dispense lever is in the dispense mode. (see Figure 6) Ice bath must

always be filled in the dispense mode.

NOTE: Non flush units does not have a flush/dispense lever hence for filling water bath on non flush units please

remove the concentrate Storage bottles first and then attach the tube to any one of the dispense nozzles

and close the door, press and hold the dispense button (push) until the tank is filled and water trickles

from the overflow

Water Bath

Fill Tube

Connection

Close the door, press and hold the dispense button (push), shown in Figure 7. Dispense Buttons, until the tank

is filled and water trickles from the overflow.

Once the ice bath is full, store the fill tube in the vertically recessed holder. The fill tube can now be used as a

"sight glass" to monitor the water level in the ice bath.

QUEST ELITE 4 Flavor Installation, Service & Decommissioning Manual