QUEST ELITE 4 Flavor Installation, Service & Decommissioning Manual
Cleaning the Cabinet
The cabinet bottom surface and walls should be inspected and cleaned annually according to the following steps:
1. Remove natural rubber nozzle bushing gasket (see Figure 17) and inspect it and silicone RTV. If cracked, clean off RTV,
and re-apply using kit P/N 729011013 per instructions provided with kit.
2. Re-apply nozzle bushing gasket so that the edges lie flat on the floor of the cabinet.
Figure 42. Nozzle bushing gaskets - proper installation
3. Clean cabinet floor and walls of any spilled juice and let dry. Use a mild soap/detergent and plain water.
4.
Reinstall the pump platform in the reverse order given above.
© 2022, Marmon Foodservice Technologies Inc.
- 39 -
Publication Number:721Q14101MNL